HERE ARE A FEW REVIEWS FROM OUR CLIENTS:
- Loved the heart shaped confetti!
- Service and product were great! The product made the pictures look amazing!
2" X 10" SLEEVES OF DIE CUT 1.5" METALLIC HEARTS
Our 2" X 10" sleeves of Die Cut Metallic Hearts are made out of the thinnest PVC flame proof film available in the marketplace. Why do we use the thinnest film because they flutter, fly and float longer in the air than a heavier film which most of our competitors use. Also, our metallic film is flame proof so if a heart falls on a candle at your event it won't burn and start a fire.
We recommend using our die cut hearts in our 2" Mega Blaster Hand Held Co2 launcher. We designed our Mega Blaster to shoot our Die Cut Metallic Hearts plus our Die Cut Metallic or Tissue Rose Petals and our Tissue or Metallic Die Cut Stars up to 30' into the air. Most dance floors are approximately 24' X 24' so you can either use (1) one or (2) Mega Blaster Launchers (One on each side of the dance floor) to totally cover it with our Metallic Hearts. This offers a "Stunning" Special Effect at your event.
Our Mega Blaster is very easy to load and shoot. First we recommend you push one of our 2 1/4" Lifting foam to the bottom of the launcher barrel. This enables the Metallic Hearts to fly high into the air. Then you remove the rubber band from the sleeve of Die Cut Metallic Hearts and sloowly insert them into the launcher barrel. Since our metallic film is so thin it is very slippery because we coat the film with a secret film to once again make it fly high into the air so be careful inserting the hearts into the barrel.
Then top the launcher barrel with our 2 1/4" paper compression cap. This cap will help build pressure to make the Metallic Hearts fly high into the air. Wrap a small piece of our Compression Tape around the diameter of the Compression Cap adhering it onto the launcher barrel. DO NOT WRAP THE TAPE OVER THE COMPRESSION CAP just around the outside diameter of it.
Then insert one 16" Co2 cylinder into our U.S. Patented trigger unit. The Co2 cylinder in our trigger unit will not leak so you can insert the Co2 long before you're going to use the launcher at your event. Our 2" X 10" Sleeve of Metallic Die Cut Hearts have approximately 3,828 hearts in each sleeve. You can choose up to 8 colors of metallic film colors to match your event's decor since our die cut metallic hearts are hand made in our factory in the USA. Be sure to choose the colors you want when ordering,
Remember to check your shipping box when it arrives for the "CERTIFIED FLUTTER FETTI® PRODUCT STICKER" on the outside of the box. To be sure it’s an authentic Flutter FETTI product.
Accessories Required For Use:
- Mega Blaster Hand Held Co2 Launcher
- 2 1/4" Lifting Foam
- 2 1/4" Compression Cap
- Roll of Compression Tape
- 1-16 Gram Co2 Cylinder
- 1 or 2 Sleeves of Die Cut Metallic Hearts (Custom Colors)
ALL ORDERS RECEIVED AFTER 3:00 P.M. Eastern Time (ET) WILL BE PROCESSED ON THE NEXT BUSINESS DAY.
Caution: Do not fire launchers loaded with Metallic Streamers with FETTI outside near any overhead wires, for our PVC streamers conduct electricity. If our streamers land on 2 power lines, you run the risk that they may short out the nearest fuse or transformer.
Caution: Do not fire launchers loaded with Metallic Streamers with FETTI outside near any overhead wires, for our PVC streamers conduct electricity. If our streamers land on 2 power lines, you run the risk that they may short out the nearest fuse or transformer.
© 2024 Parti Line International, LLC. All Rights Reserved.
